IBM OS/2
DDC Monitor Support
VESA Display Data Channel (DDC) 1 and 2B protocols are supported,allowing similarly enabled computers and operating system software to identify the monitor and its capabilities. This device driver automatically detects DDC monitor capabilities and sets the display to the maximum refresh rate supported by the monitor. If, after installing this device driver, you switch from a
Use the following procedures when installing a DDC monitor
1.Reset the display to the lowest refresh rate available. This will prevent the sys- tem from attempting to display at a refresh rate higher than that supported by the new monitor.
2.Shut down your system and install the new monitor.
3.Restart your system.
4.Select the "DDC Display Setup" icon in the OS/2 System Folder.
5.When you are instructed to do so, shut down your system and restart it.
Preliminary Steps
The following steps must be performed before you install the Vision864/964/868/ 968/Trio32/64/64V+/64V2
1.You must have OS/2 DOS Support installed.
2.If you previously installed SVGA support, you must reset the resolution to VGA mode, using the procedures in "Setting Your Display to VGA Mode" (section 5.0 in this README).
3.The device driver diskettes must be labeled "S3 DRV1" and "S3 DRV2".
A. VGA Driver
IBM OS/2
ASUS | 93 |