WINDOWS NT 4.0
E. BusMaster
This subsection describes how to install the software on a system where Windows NT Version 4.0 is installed.
NOTE: This procedure assumes that the driver (PIIXIDE.SYS), installation file (OEMSETUP.INF) and tag file (DISK1.NT) are located in the same directory. Record the locations of the driver installation and Windows NT directories before installing the driver. If the driver is installed on the system,
1.Check the System Requirements. Windows NT must be fully installed and run- ning on the system prior to installing the driver.
2.Close any running applications.
3.Select My Computer.
4.Open the Control Panel Folder.
5.Invoke the SCSI Adapters applet.
6.Click the Drivers tab. The currently installed SCSI adapter drivers will be listed in the Drivers menu. The display MAY list the default driver, "IDE
7.If the "Intel PIIX PCI Bus Master IDE Controller" driver is listed, select it. Then, select Remove to remove the driver.
8.If the default driver "IDE
9.Select Add to add a new driver.
10.From the Install Disk window, select Have Disk.
11.The Windows NT Setup dialog box will appear prompting for the path of the installation files. Specify the location of the driver installation directory when prompted to do so.
NOTE: This procedure assumes that the driver (PIIXIDE.SYS), installation file (OEMSETUP.INF) and tag file (DISK1.NT) are located in the same directory.
12.Click Intel PIIX PCI Bus Master IDE Controller and then click OK.
NOTE: If the driver was previously installed on the system, a dialog box will appear that states that driver for the "Intel PIIX PCI Bus Master IDE Controller" is already on the system. If this occurs, select New to install the new driver.
13.When prompted, reboot the system as directed in order for the changes to take effect.
E. BusMaster
WINDOWS NT 4.0
ASUS | 89 |