![](/images/backgrounds/166785/166785-11035x1.png)
6.Carefully push the optical drive
into the bay until its screw holes align with the holes on the bay
as shown.
7. Secure the optical drive with two screws on one side of the
bay.6
8.Connect a power cable from the power supply unit to the power
connector at the back of the optical drive. See page
9. Connect the IDE ribbon cable to | 10 | 9 | |
the IDE interface at the back of | |||
|
|
the optical drive, matching the
red stripe on the cable with Pin 1 on the IDE interface.
10.Connect one end of the optical drive audio cable to the
7
8
11.Make sure that the other end of the IDE ribbon cable is connected to the primary IDE connector (blue connector labeled PRI_IDE) on the motherboard. See page
12.Connect the other end of the audio cable to the
ASUS | 2 - 17 |