2.9Installing a floppy disk drive

The barebone system comes with one 3.25-inch drive bay for a floppy disk drive.

To install a floppy disk drive:

1.Remove the front panel cover.

For instructions on how to remove the front panel cover, refer to steps 1~5 of section

“2.8 Installing an optical

2

 

drive.”

 

2. Carefully insert the floppy disk drive into the floppy drive bay until the screw holes align with the holes on the bay.

3.Secure the floppy disk drive with

two screws.

3 3

4.Connect the floppy disk drive

signal cable to the signal connector at the back of the drive.

6

5. Connect the other end of the signal cable to the floppy disk

drive connector (labeled

4

 

FLOPPY) on the motherboard.

 

See page 4-8 for the connector

 

location.

 

6.Connect a power cable from the power supply unit to the power connector at the back of the floppy disk drive. See page 2-24 for details on the power supply unit plugs.

ASUS T2-PE1

2 - 19