![](/images/backgrounds/166785/166785-11038x1.png)
2.10Installing a hard disk drive (HDD)
The system supports one Ultra ATA/133 IDE or one Serial ATA hard disk drive.
To install an IDE hard disk drive:
1.Locate the HDD tray lock screw
on the other side of the chassis.
2. Remove the lock screw with a Philips screw driver. Keep the screw for later use.
1
2
3.Slide the HDD tray outward until the tray slots are released from
the chassis hooks. | Tra y locks |
| |
| 3 |
Loc k slots
Tra y locks
4. Place a hard disk drive on the
tray with its bottom on the | 5 | |
open side. Align the HDD and | ||
4 | ||
HDD tray screw holes. | ||
|
5.Secure the HDD with four
screws.
5
Configure your hard disk drive as Master device before connecting the IDE cable and power plug. Refer to the HDD documentation on how to set the drive as a Master device.
2 - 20 | Chapter 2: Basic installation |