![](/images/backgrounds/166785/166785-11034x1.png)
The Terminator 2 system comes with two
• You may install a second optical drive only if you installed a Serial ATA hard disk drive.
•Set your second optical drive as Slave device before connecting the IDE cable and power plug. Refer to the optical drive documentation on how to set the drive as a Slave device.
To install an IDE optical drive:
1.Place the chassis upright.
2. | Locate the front panel cover | 3 | 3 |
| hooks. | ||
|
| ||
|
|
| |
3. | To remove the front panel cover | 1 |
|
| from the chassis, press the top |
| 2 |
| hooks downward and the |
|
|
| bottom hooks upward to release |
|
|
| them from the metal tabs that | 3 |
|
| secure them in place. | 3 | |
|
| ||
4. | Detach the front panel cover |
|
|
| top hooks. | 4 |
|
4
5.Slightly push the front panel
cover outward until it detaches from the chassis, then set it aside.
Disconnect the front audio |
|
button panel and LED panel | 5 |
cables from their respective connectors before removing the front panel cover.
To reconnect the cables, see pages
2 - 16 | Chapter 2: Basic installation |