These connectors are for the
ATX12V1 |
| EATXPWR | ||
|
|
| ||
+12V DC |
|
|
| |
Ground | +3 | Volts | Ground | |
| +12 | Volts | +5 Volts | |
+12V DC | +12 | Volts | +5 Volts | |
Ground +5V Standby | +5 Volts | |||
| Power OK | NC | ||
| Ground | Ground | ||
| +5 | Volts | Ground | |
| Ground | Ground | ||
| +5 Volts | PSON# | ||
| Ground | Ground | ||
§ | +3 | Volts | ||
ATX12V2 | ||||
+3 | Volts | +3 Volts | ||
GND +12V DC |
| 1 |
ATX power connectors
GND +12V DC
The PRI_IDE connector is for the Ultra ATA/100 IDE hard disk ribbon cable. Connect the cable’s blue connector to the IDE connector, then connect the gray connector to a slave device (optical drive) and the black connector to the Ultra ATA/100 master device (hard disk drive). Refer to the hard disk documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole on the UltraATA cable connector. This prevents incorrect orientation when you connect the cables.
•For Ultra ATA/133 IDE devices, use an
NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.
§
IDE_
PRI
PIN 1
IDE connector
4 - 6 | Chapter 4: Motherboard info |