Case of Difficulty | AT&T 1480 specification

1480_book_1ATT 2/25 2/25/02 10:30 AM Page 29

IN CASE OF DIFFICULTY

If you have difficulty operating this phone, try the suggestions below.

For Customer Service, visit our website at www.telephones.att.com or call

1 800 222–3111.Please retain your receipt as your proof of purchase.

If the phone doesn’t work at all, check these items first:

•Make sure the ringer is on at the cordless handset and base.

•Make sure the telephone line cord is plugged firmly into the base unit and the modular jack.

•Make sure the base antenna is fully upright.

•If the handset does not beep when you press P, the battery might need charging.

•Make sure the handset battery pack is installed correctly.

•Microwave appliances may cause interference with this phone. If you experience interference, move away from the microwave

If the above suggestions don’t solve the problem, try re-initializing the handset and base:

1Disconnect the power to the base.

2Remove the handset battery pack.

3Wait a few minutes.

4Connect the power to the base.

5Insert the handset battery pack.

If you hear a two-beep signal when you try to use the handset:

•You might be out of range. Move closer to the base and try again.

•If moving closer to the base doesn’t help, try following the directions above for re-initializing the handset and base.

If the phone does not ring when you receive a call:

•Make sure the handset ringer is on.

•Make sure the telephone line cord is connected firmly to the base and the telephone jack.

•Make sure the AC adapter is plugged firmly into an outlet not controlled by a wall switch.

•You might be too far from the base; move closer.

•You might have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of them.

29

Image 32

AT&T 1480 user manual Case of Difficulty, If the phone doesn’t work at all, check these items first

Contents

Draft 2/25/02 Part 1 Important Product Information Advanced American Telephones. All rights reserved Contents Before YOU Begin About the Base and the ChargerChoosing the Best Location About Caller ID with Call Waiting About Call History Table/Desk InstallationBase Installation Wall Mount Installation Mount the base on the wall Handset Charger Installation Install the handset battery Charge the handset battery Set the phone for tone or pulse dialing base only Belt Clip Headset Telephone Operation Telephone Operation Handset Ringer Style/Battery Save Temporary Tone Dialing Base or Handset Operating Range Display Screen Messages Handset and Base Telephone Directory Store a Number/Name in the Directory Edit a Number/Name Stored in the Directory Edit Dial Erase Delete a Number/Name Stored in the Directory Dial a Number from the Directory Caller ID Operation Review Call History Delete Records from Call History Dial a Displayed NumberDelete a Specific Call Delete All Calls Display Screen Messages Turn Off the Base NEW Call IndicatorStore a Call History Record in the Directory Audible Indicators Answering System OperationSet the Clock About Mailboxes Record Your Announcement Press Uuntil you hear Change announcement Answering System Feature Setup Feature Summary Play Messages Adjust Playback VolumeListen to, Save & Delete Messages Message Window Display Call Screening/InterceptRecord a Memo Voice Menu Remote Access CommandsConnect with the Answering System End remote access call Record memoTurn system off Turn system on Charge the Handset Battery Pack Batteries Replacing the Handset Battery Pack If the phone doesn’t work at all, check these items first If the phone does not ring when you receive a callCase of Difficulty If you hear other calls while using your phone If you lose a call after changing channels If CL appears in the Message Window If messages are incompleteIf you have difficulty hearing messages If your outgoing announcement isn’t clear If callers cannot leave messages in Mailbox 2 or Remote Commands Answering System Press Machine off press #0again