Reviewing Settings, Exit Remote Access, Audible Signals | AT&T 7630

ANSWERING SYSTEM OPERATION

At Cordless Handset or Touch Tone Phone

11The system announces the Priority Calling Code, followed by "To select the first digit, press 6 or 4, then press 9."

12Follow Step 10 to change the Priority Calling Code.

13The system announces the current base ringer setting, followed by "To turn on or off, press 6 or 4."

14Press 6or 4to change the setting. Press 9to save the setting.

15Press 5to exit the set-up menu.

Reviewing Settings

1Connect with the answering system.

2Press 9. The system will announce the current settings.

Exit Remote Access

If you are using a touch tone phone, hang up the telephone. If you are using the cordless handset, press a.

Audible Signals

Sound	Meaning

Long ringing	Incoming call

Single beep	Valid button press

Three-part tone	Page

Repeating 3-part tone	Handset locator

Two short beeps	Handset is out of range

Four short beeps	Low battery

Four long beeps	Base busy

Long buzzing tone	Error - unsuccessful action

Series of ascending tones	Action has been successful

2 7

7630_book.1AT&T

27

8/12/98, 6:29 PM

Image 28

AT&T 7630 user manual Reviewing Settings, Exit Remote Access, Audible Signals

Contents

Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Set the dial mode For Wall InstallationCheck for dial tone Installation Telephone Operation Hold Temporary ToneVoice Security Page/Intercom Handset Locator Power Reserve FeatureRecording a Phone Conversation Telephone Memory Storing Memory NumbersStoring a Pause in a Memory Number OR- Press M Dialing Memory Numbers Dialing Number Stored in M1Replacing a Stored Number Memory Guard Conecting to a Call With the Speakerphone Speakerphone Volume ControlMute Operating Range Changing Channels Speaker Volume Control Setting the ClockAnswering System SET-UP Turning the System On/Off Selecting Your Announcement Announcement OptionsRecording Your Announcement Feature Set-Up Announcement Play/SilentRing Select and Toll Saver Deleting an Announcement Priority Call Signal Remote Access CodeAudible Message Alert Reviewing Feature Settings Base Ringer SettingChanging the Priority Calling Code Answering System Operation Answering CallsCall Screening/Intercept Announcement Bypass Listening to Your Messages Saving Messages Deleting Messages Message Guard Power Fail Protection SystemRecording a Memo Connecting with the Answering System From the Cordless HandsetFrom a Touch Tone Phone Voice Help Menu Playing Messages Remote Access CommandsConnect with the answering system Call Screening Recording Outgoing AnnouncementReviewing your announcement To monitor a call Changing Settings Recording a Message When System is OffRemote ON/OFF Exit Remote Access Reviewing SettingsAudible Signals Handset Batteries Replacing the Handset Battery Pack If you hear two-beep signal when you try to use the handset Case of DifficultyIf the phone does not work at all If you have no dial tone If you hear noise or interference when using the phone If the phone does not ring when you receive a callIf you hear other calls while using the phone If you hear noise in the handset and the buttons don’t work If messages are incomplete If you have difficulty hearing messagesIf CL appears in the Message Counter If your outgoing announcement isnt clear Answering System Operation 7630WC.1AT&T 12/98, 626 PM