IN CASE OF DIFFICULTY
If you have difficulty operating this telephone answering system, try the sugges- tions below. If you still have trouble, call 1 800
If the phone does not work at all
•Make sure the power cord is plugged into the base and an electrical outlet.
•Make sure the telephone line cord is plugged firmly into the base unit and the telephone jack.
•If the phone does not beep or beeps four times when you press P, the batteries might need recharging.
•If the LOW BATT light is flashing, the batteries need recharging.
•Make sure the handset battery pack is installed correctly.
•If the battery pack still will not charge, replace it with replacement battery 4051.
•If the above suggestions do not solve the problem, try resetting the security code, as described below.
•Place the handset in the base, and check to make sure the CHARG-
ING light is on. Wait 15 seconds, then pick up the handset and press P. The phone should operate properly. If it doesn’t, try the next step.
•Place the handset in the base, and check to make sure the CHARG- ING light is on. Unplug the AC adapter from the outlet, wait 15
seconds, then plug it in again. The CHARGING light should go on. Wait another 15 seconds, then pick up the handset and press P. The phone should operate properly. If it doesn’t, try the next step.
•Pick up the handset, open the battery compartment, and unplug the battery pack. Wait 15 seconds, then reinstall the battery pack, close the battery compartment, and place the handset in the base.
The CHARGING light should go on. Wait another 15 seconds, then pick up the handset and press P. The phone should operate properly.
If you hear two-beep signal when you try to use the handset
•The handset and base are not communicating properly. You might be out of range while attempting to dial. Move closer to the base and try the call again.
•If moving closer to the base does not help, the handset and base might be set to different security codes. Reset the security code, described in the section above.
If you have no dial tone
Check all the previous suggestions. If you still do not hear a dial tone, disconnect the phone and try another one in the same jack. If there is no dial tone on that phone either, the problem is probably in your wiring or local service. Call your local telephone service company.
3 0
7630_book.1AT&T | 30 | 8/12/98, 6:29 PM |
