Replacing the Handset Battery Pack

HANDSET BATTERIES

Replacing the Handset Battery Pack

1Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward.

2Lift out the old battery pack and unplug it from the handset.

3Hold the new battery pack and plug the cord into the handset. Place the battery pack and wires in the compartment, as shown below.

4Replace the cover by sliding it on its track up over the battery compart- ment until it snaps firmly in place.

5The new batteries must be charged before using this telephone. Place the handset in the base unit and allow it to charge for 4 hours. The telephone may operate before that, but for best performance, let the batteries charge fully.

2 9

7630_book.1AT&T

8/12/98, 6:29 PM

Page 30

Image 30

AT&T 7630 user manual Replacing the Handset Battery Pack

Contents

Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation For Wall Installation Set the dial modeCheck for dial tone Installation Telephone Operation Voice Security HoldTemporary Tone Page/Intercom Power Reserve Feature Handset LocatorRecording a Phone Conversation Storing a Pause in a Memory Number Telephone MemoryStoring Memory Numbers OR- Press M Replacing a Stored Number Dialing Memory NumbersDialing Number Stored in M1 Memory Guard Speakerphone Volume Control Conecting to a Call With the SpeakerphoneMute Operating Range Changing Channels Answering System SET-UP Speaker Volume ControlSetting the Clock Turning the System On/Off Announcement Options Selecting Your AnnouncementRecording Your Announcement Ring Select and Toll Saver Feature Set-UpAnnouncement Play/Silent Deleting an Announcement Remote Access Code Priority Call SignalAudible Message Alert Base Ringer Setting Reviewing Feature SettingsChanging the Priority Calling Code Call Screening/Intercept Answering System OperationAnswering Calls Announcement Bypass Listening to Your Messages Saving Messages Message Guard Power Fail Protection System Deleting MessagesRecording a Memo From a Touch Tone Phone Connecting with the Answering SystemFrom the Cordless Handset Voice Help Menu Remote Access Commands Playing MessagesConnect with the answering system Reviewing your announcement Call ScreeningRecording Outgoing Announcement To monitor a call Recording a Message When System is Off Changing SettingsRemote ON/OFF Reviewing Settings Exit Remote AccessAudible Signals Handset Batteries Replacing the Handset Battery Pack If the phone does not work at all If you hear two-beep signal when you try to use the handsetCase of Difficulty If you have no dial tone If you hear other calls while using the phone If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you hear noise in the handset and the buttons don’t work If CL appears in the Message Counter If messages are incompleteIf you have difficulty hearing messages If your outgoing announcement isnt clear Answering System Operation 7630WC.1AT&T 12/98, 626 PM