Headset jacks on the side of the Callmaster | AT&T Not Availab

Headset

Jacks

FIGURE 2 The headset jacks on the side of the CALLMASTER

On both sides of the CALLMASTER (II and III) voice terminals, as shown in Figure 2 above, there is a set of headset jacks. Use these jacks for connecting a headset to your CALLMASTER set.

NOTE: Two headsets plugged into the sides of the CALLMASTER can be used simultaneously.

If any adjunct is active, the left and right headset jacks on the voice terminal are deactivated.

7

Image 13

AT&T Not Availab installation instructions Headset jacks on the side of the Callmaster

Contents

Definity AT&T 555-015-168 Comcode 107319659 Issue 1, August To Order Copies of this Document Warranty Interference Warning Information Part 15 of FCC Rules Hearing AID Compatibility Important Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice Terminal Organization of this Guide Recorder Interface Conventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts Installation Comcode Orderable Equipment Connecting the Line and Optional Equipment Cords Installing the Callmaster Voice Terminals Line jack, adjunct jack, and routing channels Important Notes on Installation DCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or Handset Inserting the designation strips Raising or Lowering Receive Volume Feature ProceduresTo raise or lower the receive volume Going OFF-HOOK Disconnecting from Calls To add another party to an existing call Conference Hold Drop Mute Select Ring and Ringer VolumeTo prevent the other party from hearing you To select a personalized ring SELF-TEST To adjust ringer volume if necessaryTo test the lights and ringer of your voice terminal Transfer Power Requirements Physical Dimension and WeightTechnical Description Environmental Requirements