AT&T Not Availab guide

Figure 4 shows how a CALLMASTER II with Recorder Interface should be configured through the wall jack with the DEFINITY PBX, an adjunct power source, and the recording device.

NOTE: Typically, a 104A wall jack is used in this type of configuration.

13

Image 19

AT&T Not Availab installation instructions

Contents

Definity AT&T 555-015-168 Comcode 107319659 Issue 1, August To Order Copies of this Document Warranty Interference Warning Information Part 15 of FCC Rules Hearing AID Compatibility Important Safety Instructions Service Contents Headset or the Handset Your Callmaster Voice Terminal Organization of this Guide Recorder Interface Conventions Callmaster Feature DescriptionsPage To initiate a self-test of your voice terminal Headset jacks on the side of the Callmaster Checklist of Parts Installation Comcode Orderable Equipment Connecting the Line and Optional Equipment Cords Installing the Callmaster Voice Terminals Line jack, adjunct jack, and routing channels Important Notes on Installation DCP Line Interface Connector Block DCP Jack InterfacePage Callmaster Labeling and Installing the BUTTON-DESIGNATION Strips Testing the Headset or Handset Inserting the designation strips Going OFF-HOOK Feature ProceduresRaising or Lowering Receive Volume To raise or lower the receive volume Disconnecting from Calls To add another party to an existing call Conference Hold Drop To select a personalized ring Select Ring and Ringer VolumeMute To prevent the other party from hearing you SELF-TEST To adjust ringer volume if necessaryTo test the lights and ringer of your voice terminal Transfer Environmental Requirements Physical Dimension and WeightPower Requirements Technical Description