ATTO Technology 2390C/R/D ATTO FibreBridge 2390R/D, Dimensions, Fibre Channel interface, Power

1.2 ATTO FibreBridge 2390R/D

The ATTO FibreBridge 2390R/D is a 4-Gigabit Fibre Channel to SCSI bridge offering the ability to add 4-Gigabit Fibre Channel connectivity to Ultra320 SCSI devices.

The FibreBridge 2390R/D is available in an industry- standard IU form factor for easy integration into racks. The advanced connectivity options make it suitable to support next-generation storage media such as LTO-3 and SDLT600.

Default values are appropriate for most applications. Refer to Configuring the FibreBridge on page 15 for more information.

Battery-backed event log SRAM & Real-Time- Clock: A rechargeable Lithium ion battery cell holds the memory in a 512KB SRAM for up to 30 days.

WARNING

Risk of explosion if the battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.

Dimensions

Width: 16.494 inches

Length: 10 inches

Height: 1.579 inches (1U)

Weight: approximately 10 pounds

Cooling and airflow

Operating temperature: 0-40 °C external

Humidity: 10-90% non-condensing

Air enters from the front and is exhausted out the connector side. Ambient air near the inlets should not exceed 40 °C. The unit automatically stops operation if the temperature goes beyond this threshold.

CAUTION

Do not block the enclosure’s vents. The FibreBridge does not allow data transfer if overheating occurs.

Power

The power supply circuit is permanently mounted within the enclosure and is not hot swappable. It has one standard IEC320 power receptacle and switch.

The universal power supply provides power for the bridge board and cooling fan.

Explosionsgefahr, wenn die Batterie falsch entfernt und/oder ersetzt wird. Entsorgen Sie benutzte Batterien in Übereinstimmung mit Ihren lokalen Umweltschutzbestimmungen.

If the FibreBridge becomes disconnected from power, recharging begins automatically when power is restored to the system. The battery is fully charged after 24 hours of continuous power application.

Fibre Channel interface

The optical SFP 4-Gb Fibre Channel port auto- negotiates to 1-Gb, 2-Gb or 4-Gb devices.

SCSI ports

The two independent SCSI ports are Ultra320 SCSI busses with VHDCI connector, downward compatible with all forms of single-ended SCSI and all previous SCSI protocols.

Management ports

The 10/100 Base T Ethernet port is accessible from the RJ-45 connector to support local and remote diagnostics, monitoring and management.

The power requirements of the ATTO FibreBridge 2390R plus the power draw of the other equipment in the rack must not overload the supply circuit and/or wiring of the rack.

Input voltage: 110/230V AC, with operating input range of 90-132V AC or 175-264V AC, 100-240 VAC; 1.7-.7A, 50-60Hz.

The RS-232 serial port provides support for remote monitoring and management using a DB9 connector. The baud rate is programmable and preset at the factory to 115200 bps.

1	6
RX 2
	7
TX 3
	8
4
	9
GND 5

5

ATTO Technology Inc. FibreBridge Installation and Operation Manual