Command explanations
AutoLogSense
Controls whether current data from log pages in a SCSI target device is available automatically.
Default: disabled
set AutoLogSense [enableddisabled] Requires a SaveConfiguration command get AutoLogSense
AutoMap
Automatically assigns a subset of source protocol LUNs to a subset of target destination devices visible to the FibreBridge. All previous maps are deleted.The unit reports a
FCMultiNode (FB2400 only) enabled: AutoMap <fp> All other models and FC2400 with FCMultiNode disabled:
AutoMap
Requires a SaveConfiguration command
BootFibreDelay
Regulates the delay (in seconds) which the FibreBridge waits until after startup before enabling Fibre Channel ports.
Default: 0 (no delay)
set BootFibreDelay [0 15 30 45 60 75] Requires a SaveConfiguration command get BootFibreDelay
BootScan
Provides dynamic mapping of SCSI devices to the Fibre port/LUN combination via a SCSI bus scan at boot time. All devices discovered during the bus scans are assigned to a Fibre port, Fibre LUN combination until the next reset/power cycle. This dynamic mapping replaces the current, static mapping of the FibreBridge.
Default: disabled
set BootScan [enabled disabled] Requires a SaveConfiguration command get BootScan
BootScanPorts (FB2400 only)
Regulates the ports to be used for a boot scan.
Default: auto
set BootScanPorts [fp all auto] Requires a SaveConfiguration command get BootScanPorts
BridgeModel
Reports model and firmware information about the FibreBridge.
get BridgeModel
BridgeName
Specifies the
Default: “ “
set BridgeName [name] get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are recorded until the operation is completed.
ClearEventLog
ClearTraceLog
Clears the contents of the trace log. No events are recorded until the operation is completed.
ClearTraceLog
Date
Sets/displays the date. The range is 01/01/2000 to 12/31/2099.
Default: 01/01/2000
set Date [MM] / [DD] / [YYYY]
Requires a SaveConfiguration command get Date
DeleteAllMaps
Removes all mapped devices from the map table. Upon the subsequent POST, if no maps are present, the default maps are loaded.
DeleteAllMaps
Requires a SaveConfiguration command
DHCPFixedDelay
Regulates or displays the delay (in seconds) between DHCP client request intervals.
Default: 0
set DHCPFixedDelay
Requires a SaveConfiguration Restart command get DHCPFixedDelay
vi