ATTO Technology 2370E, 2390C/R/D Install the FibreBridge, Unpack the packing box verify contents

2.0 Install the FibreBridge

If you have not already completed the instructions on the Quick Start page packed with your FibreBridge, use the following instructions to install the FibreBridge.

Unpack the packing box; verify contents

•The FibreBridge. Note the serial number of your FibreBridge unit: ________________________

•Power cord

•“L” brackets for mounting in a 19” rack

•Ethernet cable

•RS 232 cable

•CD which includes the Firmware, Installation and Operation Manual, QuickNAV™ IP discovery program and system drivers

Install the FibreBridge

1Place the FibreBridge on a stable flat surface, install it into a standard rack or into your device.

If installing the Fibre Bridge 2390R/D or the FibreBridge 2400 R/D into a rack, see Exhibit 2.0-1and follow these instructions:

a.Attach “L” brackets so that the front side with the LEDs face front and the connector side is at the back.

b.Install the FibreBridge horizontally within the rack so it does not reduce the air flow within the rack.

2Connect and power up Fibre Channel devices from your SAN to the FibreBridge using SFPs and multimode fiber optic cables for the Fibre Channel ports. Keep cable lengths as short as possible to ensure the highest signal quality and performance. Refer to Cabling on page i of the Appendix.

3Connect and power up SCSI target devices. Refer to Cabling on page i of the Appendix.

4Connect the Ethernet port to your network.

5Connect power according to the FibreBridge model:

•For the FibreBridge 2370E, FibreBridge 2390C and Fibre Bridge 2400C, connect the power connector to the FibreBridge.

•For the FibreBridge 2390C and FibreBridge 2400C, power is already connected if you have installed the unit using the cPCI connection.

•For the FibreBridge 2390R/D and the FibreBridge 2400R/D, connect the AC power cord from the FibreBridge to the proper AC source outlet and turn on the power using the power switch.

CAUTION

The power source must be connected to a protective earth ground and comply with local electrical codes. Improper grounding may result in an electrical shock or damage to the unit.

If you are using a rack:

a.Properly ground the FibreBridge to the rack equipment. The earth ground connection must be maintained.

b.The power requirements plus the power draw of the other equipment in the rack

must not overload the supply circuit and/or wiring of the rack.

6Wait up to two minutes for the FibreBridge Ready LED to light indicating the FibreBridge has completed its power-on self test sequence.

Discover the IP address

Note

The FibreBridge is initially configured with DHCP enabled. It is best if you have access to a DHCP server.

1Work from the computer attached to the FibreBridge Ethernet port on the same domain. From the CD supplied with your FibreBridge, run the QuickNav Utility QuickNAV- windows.exe for Windows or QuickNAV-Macfor Mac OS X.

2Locate the FibreBridge with the serial number recorded earlier.

3Highlight the serial number.

4Click Next.

If a DHCP server is available on your network, an address is assigned automatically by the server. Note the assigned address:

_____________________________________

13

ATTO Technology Inc. FibreBridge Installation and Operation Manual