3Enter the Administrator (Admin) password where indicated.
4Enter appropriate information into the New
Admin Password, Confirm New Admin Password or New Read Only Password and Confirm New Read Only Password text boxes.
5Click Submit.
6If you have completed all changes for this session, go to the Restart page and restart the Fibre Bridge.
Enhance performance
SpeedWrite is a method to improve the performance of WRITE commands to SCSI tape devices attached to the FibreBridge.
Using the CLI command SpeedWrite, you can specify the SCSI bus, target and LUN of a
mapped device or specify [all] to set or get the state of all currently mapped SCSI devices.
SpeedWriteDefault specifies the state of SpeedWrite for any SCSI devices mapped manually or via an AutoMap operation. If enabled, any new SCSI device uses SpeedWrite performance enhancement by default.
1Follow the Preliminary steps.
2From the left hand menu, click on Storage
Management.
3Select the parameters you wish to change.
4Click Submit.
5If you have completed all changes for this session, go to the Restart page and restart the FibreBridge.
16
