1.3 ATTO FibreBridge 2390C
The ATTO FibreBridge 2390C is a
The FibreBridge 23900C is available in an industry- standard 4U cPCI card. Default values are appropriate for most applications. Refer to Configuring the FibreBridge on page 15 for more information.
Fibre Channel port
The
Board dimensions
Width: 6.1939 inches
Length: 6.299 inches
Height of tallest component: .545 inches
Cooling and airflow
Operating temperature:
Humidity:
Power6-pinconnectionpinouts
The FibreBridge | NU | 5V | GND | 5V | 5V | GND |
board may be | 1 | 2 | 3 | 4 | 5 | 6 |
powered from the | ||||||
cPCI backplane |
|
|
|
|
|
|
connector or a
Input voltage: 5.0V
Power draw: 30 Watts
WARNING WARNING
Risk of explosion if the battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch entfernt und/oder ersetzt wird. Entsorgen Sie benutzte Batterien in Übereinstimmung mit Ihren lokalen Umweltschutzbestimmungen.
If the FibreBridge becomes disconnected from power, recharging begins automatically when power is restored to the system. The battery is fully charged after 24 hours of continuous power application.
SCSI ports
The two SCSI ports connect storage devices into the Fibre Channel Storage Area Network (SAN). Each port is totally independent from the other.
The ports are Ultra320 SCSI busses with VHDCI connectors, downward compatible with all forms of
Management access
The 10/100 Base T Ethernet port is accessible from the
A serial
232remote monitoring and management port through a Command
Line Interface. The baud rate is programmable and preset at the factory to 115200 bps.
Manual reset switch
A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button for no more than three seconds.
To restore factory defaults, press the reset button for more than four seconds until the green Ready LED blinks.
LED indicators
The
SCSI ports: a green LED indicates activity if it is lit, no activity if it is off.
Fibre Channel port: A lighted green LED indicates link; off means no link. A separate green LED indicates activity if it is lit, no activity if it is off.
7
ATTO Technology Inc. FibreBridge Installation and Operation Manual