Sony SDX-1100V Scsi ID Number Jumper, Termination Power Switch, DIP SW Mode, Scsi ID3 ID2 ID1 ID0

3.Installation

ON

OFF

									1	DR (Desaster Recovery) Mode
									2	Emulation Mode
									3	AIT Library Interface Mode
									4	Reserved
									5	Terminator Power (ON)
									6	Periodic Cleaning Req (ON)
									7	DC Control-1
1 2 3		4		5 6		7	8		8	DC Control-2
					Figure 3-2: DIP Switch Positions
						Table 3-1: Drive Mode
	DIP SW	1		2		3		4		MODE
			OFF	OFF		ON		OFF		Normal
			ON	OFF		OFF		OFF		DR Mode
			OFF		ON	OFF		OFF		SDX-900V Emulation Mode
			OFF	OFF		ON		OFF		Library Mode

Table 3-2: Periodic Cleaning Request (Refer to 4.6.1.2)

DIP SW 6	Definition
OFF	Disable Periodic Cleaning Request
ON	Enable Periodic Cleaning Request

3.1.1.SCSI ID Number Jumper

The SCSI ID number of the SDX-1100V is selected by the SCSI ID number jumpers. The figure below shows the jumper configuration for each of the possible SCSI IDs.

SCSI	ID3 ID2 ID1 ID0
0	:	:	:	:
1	:	:	:		Parity Disable
2	:	:		:
3	:	:				No Connection
4	:		:	:			ID3
5	:		:					ID2
6	:			:					ID1
7	:									ID0
8		:	:	:
9		:	:
10		:		:
11		:
12			:	:
13			:
14				:
15					Figure 3-3: Jumper positions
: = OPEN			Jumper not installed
= CLOSED			Jumper installed

3.1.2.Termination Power Switch

Position 5 of DIP switch is used to set whether SDX-1100V provides the termination power to pin 17,18,51,52 on SCSI bus, or not.

3-2 SONY AIT-5 drive SDX-1100V series Ver.1.0