6.Command Specification SPACE
SONY AIT-5 drive SDX-1100V series Ver.1.0
6-100
Table 6-100: SPACE CHECK CONDITION results
Sense Data
Spacing Event
Detected Valid Mark
EOM Sense Key ASC/ASCQ Note
Blocks
Filemarks
Setmarks
EOD
Filemark
Setmark
EOD
BOT
Phy EOT
Setmark
EOD
BOT
Phy.EOT
EOD
BOT
Phy.EOT
BOT
Phy.EOT
1
1
1
1
1
1
1
1
1
1
1
1
0
0
1
1
0
0
0
1
0
0
0
0
0
0
0
0
0
0
0
1
1
0
0
1
1
0
1
1
1
1
No Sense
No Sense
Blank Check
No Sense
Medium Error
No Sense
Blank Check
No Sense
Medium Error
Blank Check
No Sense
Medium Error
No Sense
Medium Error
Filemark Detected
Setmark Detected
BOM/P Detected
EOM/P Detected
Setmark Detected
BOM/P Detected
EOM/P Detected
BOM/P Detected
EOM/P Detected
BOM/P Detected
EOM/P Detected
a,b
a,b,d
b
b,e
b,f
a,b,d
b
b,e
b,f
b
b,e
b,f
c,e
c,f
Note a: The logical position is located on the EOM side of the mark if the movement was in the forward direction
and on the BOM side of the mark if movement was in the reverse direction.
Note b: The Information field in the Sense Data is set to the difference (residue) between the requested count and
the actual number of blocks, Filemarks, Setmarks, or spaced over.
Note c: The Information field in the Sense Data will contain no residue count and therefore the Valid bit is not set.
Note d: If it has been configured through MODE SELECT to Report Setmarks, the drive will only report that a
Setmark has been detected while spacing over blocks or Filemarks. Otherwise, the drive will continue the space
operation and the presence of the Setmark will be transparent to the nitiator.
Note e: The tape is physically positioned at BOM/P.
Note f: EOM is only reported when the physical EOM/P is encountered. The tape is physically positioned at
EOM/P.