Sony SDX-1100V/R manual Parameter Value Invalid, Saving Parameters not Supported

REQUEST SENSE 6.Command Specification

04h			HARDWARE ERROR. Indicates that the drive detected a non-recoverable hardware
			failure not related to the tape (for example, controller failure, device failure, parity
			error, etc).While performing the command or during a self-test. If a previously
			acknowledged write-type operation was the cause, the valid bit is set. The error code
			in sense byte 16 will indicate the specific problem. Refer to the error code table in the
			diagnostics clause for more information.
	03	00	PERIPHERAL DEVICE WRITE FAULT - Drive electronics did not report successful
			completion to a Write operation.
	3F	01	MICROCODE HAS BEEN CHANGED – Illegal firmware code is reprogrammed.
	44	00	INTERNAL TARGET FAILURE - Any unexpected internal error
			Conditions Indicating a Non-recoverable hardware failure. Refer to the field
			replaceable unit code field (sense byte 14) to determine which part of the drive is
			failing. Initiator will issue SEND DIAGNOSTICS with the self-test bit set to thoroughly
			test the drive. This sense information could also be returned after a send diagnostics
			command ends with a CHECK CONDITION status. initiator will issue RECEIVE
			DIAGNOSTICS RESULTS for more details. Possible causes: buffer
			overrun/under-run, format violation, mechanical status time-out, internal data parity
			error, byte count mismatch, incorrect micro processor operation, unexpected SCSI
			protocol chip interrupt.
	83	06	MIC Read Error
05h			ILLEGAL REQUEST. Indicates that there was an illegal parameter in the CDB or in
			the additional parameters supplied as data for some commands. If the target detects
			an invalid parameter in the CDB, then it will terminate the command without altering
			the medium. If the target detects an invalid parameter in the additional parameters
			supplied as data, then the target may have already altered the medium. This sense
			key may also indicate that an invalid IDENTIFY message was received.
	1A	00	PARAMETER LIST LENGTH ERROR - Indicates that the Parameter Length error in
			the CDB. Either the value does not fall on a Header, Page or Block descriptor
			boundary or the Parameter List Length is unexpectedly large.
	20	00	INVALID COMMAND OPERATION CODE - Invalid or Unsupported command.
	24	00	INVALID FIELD IN CDB – Bits are set in one or more fields are not supported or are
			Reserved. Refer to the Field Pointer (Bytes 15-17) to identify the illegal bit or field.
	26	00	INVALID FIELD IN PARAMETER LIST - Test Number,
			Configuration Number Header, or Field in the Parameter List was invalid or selected
			Diagnostic test is not initiator assessable.
	26	01	PARAMETER NOT SUPPORTED - Unsupported page requested. Refer to the Field
			Pointer (Bytes 15-17) to identify the illegal bit or field.
	26	02	PARAMETER VALUE INVALID
	2C	00	COMMAND SEQUENCE ERROR - Write Buffer command when tape is inserted and
			not at BOT.
	39	00	SAVING PARAMETERS NOT SUPPORTED
	3D	00	INVALID BITS IN IDENTIFY MESSAGE - Identify message was not 80h or C0h.

SONY AIT-5 drive SDX-1100V series Ver.1.0 6-89