Receiver Controls and Functions (Continued)
Receiver Functions
Function Menu Default Value Choices (Edit) ▲▼ Wrap-around*
▲▼ Frequency Lowest in band†200 discrete frequencies Yes
▲▼ Scan**/*** No value Scan start --
▲▼ Lock NO.LOC NO.LOC ALL.LOC PC.LOC RX.LOC Yes
▲▼ Antenna Power** OFF OFF ON Yes
▲▼ Squelch - (one bar) 15 steps, 2 dB each No
▲▼ Meter NORMAL NORMAL HOLD Yes
▲▼ Preset PRESET Press once, then select LOAD or STORE Yes
▲▼ LOAD: DEF DEF (default), PRSET1 through PRSET5 Yes
▲▼ STORE: PRSET1 PRSET1 through PRSET5 Yes
▲▼ Quit (exit Menu) QUIT Press Mode/Set once to exit --
* Continue in the same Up/Down direction and choices “wrap around” to the other end of the range.
** AEW-R5200: Scan and Antenna Power selections in LCD menu on Channel 1 only.
*** Scan selection is not available when the receiver has been linked as a slave unit.
†Band C: 541.500 MHz; Band D: 655.500 MHz
Table 1. Receiver Functions
17
To load(recall) a Preset:
1.Touch the Mode/Set button once to move to Menu mode.
2.Touch the Up arrow twice. LCD top line shows “PRESET.”
3.Touch the Mode/Set button once. “LOAD” (or “STORE”)
appears in the LCD.
4.If needed, touch the Up arrow once to change the selection
to “LOAD.”
5.Hold the Mode/Set button. The name of the currently
loaded Preset appears on the second line of the LCD.
6.Touch the Up or Down arrow to cycle through the available
choices, stopping on the desired choice.
7.Hold the Mode/Set button until “LOADED” appears briefly in
the LCD. The receiver reverts to normal operation with the
selected preset’s functions loaded. The top display line
indicates the loaded preset and the bottom line the current
frequency.
To revert to factory-default values:
1.Touch the Mode/Set button once to move to Menu mode.
2.Touch the Up arrow twice. “PRESET” shows in the LCD
window.
3.Touch the Mode/Set button once. “LOAD” (or “STORE”)
appears in the LCD.
4.Touch the Up arrow once, if needed, to change the
selection to “LOAD.”
5.Hold the Mode/Set button. The name of the currently
loaded Preset appears on the second line of the LCD.
6.Touch the Up/Down arrow buttons to cycle through the
available choices until “DEF” appears in the display.
7.Hold the Mode/Set button to load the factory default
settings. “LOADED” appears briefly in the LCD. The receiver
then reverts to normal operation at factory-default values.
“DEF” appears in the upper line of the LCD.
Note: Loading the default setting will also revert the
receiver frequency to the default value of 541.500 (Band C)
or 655.500 (Band D).