Avalon Stoves 745, 790 owner manual Insert Installation for qualified installers only, N O T E

Insert Installation (for qualified installers only) 21

Insert with Positive Connection

N O T E :

Most factory-built chimney manufacturers make stainless steel chimney liners, either flexible or rigid. This provides a wide variety of installation options. Make sure to follow the manufacturer's instructions for installation and support.

Install a non-combustible cover plate to prevent water from entering the chimney

NOTE: This installation may be used with a masonry or zero clearance fireplace. The requirements in the section "Masonry Fireplace Requirements" or "Zero Clearance Fireplaace Requirements" must be fulfilled prior to installation.

Combustible Mantle

Surround Panels

See the section "Insert Placement Requirements" for minimum clearances and hearth required.

Cap (prevents water

from entering)

Flue Liner

The liner must be stainless steel connector or flexible vent. Follow the liner manufacturer's

insturctions for installation and

support.

Airtight Insulated Clean-Out

Remove damper or wire it open

Insert with Direct Connection (Masonry Fireplace)

N O T E :

Direct connections require installation of an airtight block-off plate or damper adapter (see "Block-off Plate Installation" on page 20).

NOTE: This installation may be used with a masonry or zero clearance fireplace. This illustration depicts a masonry insert, all requirements in the section "Masonry Fireplace Requirements" must be fulfilled prior to installation.

Combustible Mantle

Surround Panels

Flue

Liner

Stainless steel chimney connector must Extend 1' past the block-off plate or to the flue liner

Airtight

Insulated

Clean-Out

Remove damper or wire it open

See the section

"Insert Placement

Requirements" for

minimum clearances

and hearth required.

Block-off plate or damper adapter

Travis Industries 93508133 4 020509