Avalon Stoves 790 Stove Installation for qualified installers only, C o n n e c t i o n, N O T E

16 Stove Installation (for qualified installers only)

H e a r t h S t o v e D i r e c t

C o n n e c t i o n

N O T E :

Direct connections require installation of an airtight, non- combustible block-off plate or damper adapter

NOTE: The chimney must have a clay tile liner. If it does not, the installation must use a positive connection (full reline). The entire fireplace and chimney must be clean, undamaged, and meet all local building codes (UBC, etc.). Damage must be repaired prior to installation. The chimney must be 15' to 33' tall.

Max. 8”

Combustible Mantle

Min. 18"

Floor Protection

(See the section "Floor Protection Requirements" for more details)

Clay

Liner

Stainless steel chimney connector must Extend 1' past the block-off plate or to the flue liner

Airtight

Insulated

Clean-Out

Remove damper or wire it open

Block-off plate or damper adapter

See the section "Stove Placement Requirements" for minimum clearances required.

Interior or Exterior Masonry Chimney

N O T E :

This type of installation requires a UBC approved masonry connector or a factory built (U.L. Listed) wall thimble.

NOTE: The chimney must have a
clay tile liner. If it does not, the
installation must use a positive
connection (full reline). The
entire fireplace and chimney must
be clean, undamaged, and meet
all local building codes (UBC,	Min. 18"
etc.). Damage must be repaired
	clearance
prior to installation. The chimney
	to ceiling
must be 15' to 33' tall.

See the section "Stove Placement Requirements" for minimum clearances required.

Chimney connector sections

See the section

"Floor Protection

Requirements"

Clay Liner

This type of installation requires a UBC approved masonry connector or a factory built (U.L. Listed) wall thimble.

Make sure the clean-out seals in place.

Travis Industries 93508133 4 020509