Avalon Stoves 790 Insert Installation for qualified installers only, Insert with, Direct, Z . C

22Insert Installation (for qualified installers only)

	NOTE: This installation may be
Insert with	used with a masonry or zero
	clearance fireplace. This
Direct	illustration depicts a zero
Connection	clearance insert, all requirements
	in the section "Zero Clearance
(Z . C .	Fireplace Requirements" must be
	fulfilled prior to installation.
Fireplace)		Stainless steel
		chimney connector
		must Extend 1' past
		the block-off plate.

N O T E :	Combustible Mantle
Direct
connections	Surround Panels
require installation		Damper must
of an airtight		be removed
block-off plate or	See the section
damper adapter	"Insert Placement	Block-off plate or
(see "Block-off	Requirements" for
	minimum clearances	damper adapter
Plate Installation"	and hearth required.
on page 20)
		Z.C. (Metal) firebox

		Optional
		Telescoping Legs
Insert	with	NOTE: This installation may be
		used with a masonry fireplace
Face	Seal	only. The requirements in the
		section "Masonry Fireplace
Connection		Requirements" must be fulfilled
		prior to installation.

N O T E :	Flue
Face seal	Liner
connections
require installation	Combustible Mantle
of the surround
panels and	Surround Panels with
insulation (see the
"Surround Panel	insulation (see "Surround
	Panels" installation
Installation" on	instructions in the back of
page 42)	the manual)
	See the section "Insert
	Placement Requirements"
	for minimum clearances
	and hearth required.

No modification to the firebox of the z.c. fireplace is allowed.

NOTE: It is recommended your chimney have a minimum 28 and a maximum of 144 square inch cross- sectional area to use a face seal connection, otherwise your chimney maynot have sufficient draw for the fireplace insert to operate correctly.

Airtight Insulated

Clean-Out

Remove damper or wire it open

Travis Industries 93508133 4 020509