38 | Optional Equipment |
Outside Air Installation (for wood stoves only)
This pedestal has an internal air duct that may be used to direct air to the combustion chamber. Follow the directions below prior to installing the stove or attaching the pedestal.
!
+
Outside air is required for mobile home installations and in certain localities.
Read the section "Outside Air Requirements" in the owner's manual prior to installing outside air.
1 Before placing the stove on pedestal, determine the location of the hole that is cut through the floor protection and floor. The illustration to the right details the location where this hole may be cut in relation to the faceplate of the stove. Cut a hole at least 16 square inches in area that does not interfere with structural members of the home.
Top View
FRONT
The faceplate of the Pendleton (745/790) and Rainier (945/990) is
26" |
16" |
17" |
Outside air may be drawn from this area underneath the pedestal
(min. 16 square inches)
Pedestal Base (without dowels)
2 Place the included screen (or other screen) over the hole to act as a rodent barrier. It may be attached above or below the floor. Secure the screen with the included staples.
OUTSIDE AIR EQUIPMENT
Cover plate is used to block off room air .
Insulation is used to seal the side edges of the pedestal .
Screen is used to prevent 
rodents from entering. 
Staples are used to attach the screen to the floor.
3 Prop the front of the stove up 12" and pry out the outside air knockout with a large screwdriver.
Drop Chute
FRONT OF STOVE
Outside Air
Ashpan Pedestal/Air Boot Outside Air
DO NOT REMOVE
Rear Blower
5 The cover plate seals the area around the air control rod. Remove the two screws and bridge from the cover plate. Slide the cover plate underneath the air control rod and
Travis Industries | 93508133 | 4 020509 |
