Avaya M-ACCF/SF manual Switch Command Line Interface CLI, Commands Summary Table

Chapter 4 X-Switch CLI & ATM Terminal Interface

X-Switch Command Line Interface (CLI)

This is the Command Line Interface (CLI) used with the ATM module. Most parameters are set using the Terminal Interace (see ATM Access Module Terminal Interface for Configuring ATM Parameters58).

To begin using the ATM access module you must first assign an IP address and ATM capabilities to the module via the CLI (see ATM IP Configuration46).

You can either connect a VT-100 terminal or PC with VT-100 emulation to the Console port of the M-SPX/S Supervisor module or Telnet the M-SPX/S Switch IP address.

Following is a list of commands available using this CLI:

Commands Summary Table
Following is a table of the		show commands:
1.	Reset the	Enables you to perform a module reset	Page 52
	Module
2.	Software	Enables you to download new software	Page 53
	Download	to the X-Switch entity of the M-ACC
		module
3.	Set Primary	Enables you to select one of the two	Page 55
	Version	internal S/W versions as the Primary
4.	Set Factory	Resets the module back to its preset	Page 55
	Defaults	Factory Default settings
5.	Create Report	For use by Technical Support Personnel	Page 55
		only
6.	Clear Mac	Enables you to delete the MAC Address	Page 56
	Address Table	Table of the Avaya M770 switch domain
7.	Configuration	Enables you to copy the configuration	Page 56
	Copy	settings of another module to the M-ACC
8.	ATM IP	Enables you to set the default parameters	Page 56
	Configuration	of the ATM entity of the M-ACC module

To connect to the M-SPX/S Console port

1Use the serial cable supplied to attach the RJ-45 console connector to the Console port of the M-SPX/S Supervisor module and the DB-9 connector to the serial (COM) port on your PC/terminal.

2Ensure that the serial port settings on the PC are 9600 baud, 8 bits, 1 stop bit and no parity.

3If you connected a PC, run a VT-100 emulation session. (You can use the Windows® HyperTerminal.)

Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide 51