Avaya M-ACCF/SF manual Setting up an ATM VLAN/ELAN, Upgrading Software, Preliminaries, Downloading

Chapter 4 X-Switch CLI & ATM Terminal Interface

Setting up an ATM VLAN/ELAN

1Go to the VN [4] submenu.

2Select [3] Create.

3Enter the VN number (2 to 16), the 802.1Q tag as configured in the ATM access module VLAN settings (2 to 254, not 17 - for internal use) and the ELAN name as configured in the LECS.

4Observe creation and enabling of a new VLAN/ELAN using the Display [1] option in the VN menu.

Upgrading Software

This section describes how to upgrade the ATM access module software. You can upgrade software either via the CajunView NMS or by using the Terminal Interface.

Preliminaries

Upgrading the ATM access module software takes place in three stages via a TFTP server:

•Preparing local management

•Actual downloading (filename: Piccolo.tsl)

•Resetting the device.

Before starting the TFTP upgrade procedure, make sure that the software file resides on the TFTP local disk.

Downloading

1Set the TFTP server to server mode.

2Change the TFTP server directory to the directory where the software version file is located.

3Open a Telnet session to the ATM access module Control port.

4From the correct ATM access module menu, select System/swUpgrade/load [1,6,1] to perform the TFTP download.

The following message appears:

Server IP address:

File to be downloaded:

5Type the correct TFTP Server IP address and press <Enter>.

6Type in the file to be loaded and press <Enter>.

7You can use the System Progress [1,6,2] menu item to check the progress of the download. Progress is reported in percentage of the file size until completion.

8Menu Item Status [1,6,3] displays the latest download status (see Caution).

Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide 75