i

The Motion Detection must be enabled first, the alarm sending

mail will send out the mail when detect motion.

 

 

 

-Alarm Out Time

Set the amount of time (in second) to continue sending the alarm once activated

(2)Sensor Setup

-Sensor Status

Customize the initial state of the attached sensor for every camera. Refer to the table below to customize the sensor state.

Not installed: Indicates that there is no sensor connected

Normal open: Indicates that the initial state of the sensor is normal open. Video recording initiate when there is a changes in the sensor state

Normal close: Indicates that the initial state of the sensor is normal close. Video recording initiate when there is a changes in the sensor state

-Sensor Record Time

Set the amount of time (in second) to record after the sensor has been triggered

(3)E-Mail Setup

-SMTP

Enter the SMTP server

-User ID & Password

Enter User ID and Password for e-mail server user identification

-From

Enter the sender e-mail address

-To

The recipient e-mail address and separate it with a semicolon

-Subject

Enter the message title

-Message

Type the message

40