Chapter 5: CPS Appliance Commands | 63 |
|
|
Table 5.26 and Table 5.27 list the display fields for a Show Port command that specifies one or all ports.
Table 5.26: Show Port Command Display Fields for Console Ports
Field | Content | |
|
| |
Port | Port number. | |
|
| |
| ||
Serial Port Settings | flow control, socket number, | |
command). The CLI character is preceded by POR CLI= if it was defined with a Port | ||
| ||
| Set command or by SER CLI= if it was defined with a Server CLI command. | |
|
| |
TX Bytes | Number of bytes transmitted. | |
|
| |
RX Bytes | Number of bytes received. | |
|
| |
Errors | Number of TX/RX parity and framing errors. | |
|
| |
Power | Device power status, if monitoring is enabled. ON indicates the device is on, OFF | |
indicates the device is off. If monitoring is disabled, this field is blank. | ||
| ||
|
| |
Toggle ** | Toggle value (from Port Set command). | |
|
| |
Power Signal ** | Signal and state being monitored for device power status (from Port Set command). | |
|
| |
Logical name ** | Logical port name, which contains last three octets of MAC address plus the | |
port number. | ||
| ||
|
| |
User * | Username (from User Add command). | |
|
| |
Level * | User’s access level (from User Add and User Set Access commands). | |
|
| |
Access * | User’s access rights (from User Add and User Set Access commands). | |
|
| |
Duration * | Duration of user’s session. |
*Displayed only when the command specifies a single port that is currently being accessed.
**Displayed only when the command specifies a single port that is not being accessed.
Table 5.27: Show Port Command Display Fields for SPC Ports
Field | Content | |
|
| |
Status | ONLINE indicates the SPC device is powered on, OFFLINE indicates the SPC | |
device is powered off. | ||
| ||
|
| |
Version | SPC firmware version. | |
|
| |
Sockets | Number of sockets on the SPC device. | |
|
| |
Minload | Minimum load amp value (from SPC command). | |
|
| |
Maxload | Maximum load amp value (from SPC command). | |
|
|