32CPS Installer/User Guide
2.To disable SNMP traps, issue a Server SNMP Trap command with the Disable parameter.
SERVER SNMP TRAP DISABLE
The CPS appliance will display a numbered list of traps that are currently enabled with a prompt requesting you to select trap(s) to disable. Indicate the traps to be disabled by entering a trap’s list number, several numbers separated by commas, a range of numbers separated by a dash or a combination of numbers with commas and dashes. To disable all traps, type ALL. To cancel the command, press Enter.
- or -
To disable all SNMP traps, issue a Server SNMP Trap command with the Disable and All parameters. In this case, the numbered list is not displayed.
SERVER SNMP TRAP DISABLE ALL
For more information, see Server SNMP Trap command on page 59 and Supported Traps on page 82.
To add or delete SNMP trap destination addresses:
1.To add an SNMP trap destination address, issue a Server SNMP Trap Destination command with the Add parameter and the destination’s IP address. You may define up to four destination addresses, using separate commands.
SERVER SNMP TRAP DESTINATION ADD <ip_address>
2.To delete an SNMP trap destination address, issue a Server SNMP Trap Destination command with the Delete parameter and the destination’s IP address.
SERVER SNMP TRAP DESTINATION DELETE <ip_address>
For more information, see Server SNMP Trap Destination command on page 60.
To add, copy or delete port alert strings:
1.To add a port alert string, issue a Port Alert Add command, specifying the port number and a 3- 32 character string. You may define up to ten strings for each port, using separate commands.
The alert string will only generate a trap if the PortAlert trap is enabled with a Server SNMP Trap command.
PORT <port> ALERT ADD “<string>”
2.To delete a port alert string, issue a Port Alert Delete command, specifying a port number. PORT <port> ALERT DELETE
The CPS appliance displays a numbered list of alert strings that have been defined for the specified port with a prompt requesting you to select alert string(s) to delete. Indicate the alert strings to be deleted by entering an alert string’s list number, several numbers separated by commas, a range of numbers separated by a dash or a combination of numbers with commas and dashes. To delete all alert strings, type ALL. To cancel the command, press Enter.
3.To copy the defined alert strings from one port to another port, issue a Port Alert Copy com- mand, specifying the port numbers to be copied to and from.