14EVR1500 Installer/User Guide
To use a terminal or terminal emulation program:
1.After mounting the appliance, connect a terminal or PC running terminal emulation software to the serial port on the back panel of the EVR1500 environmental monitor appliance using the supplied null modem cable. Configure your terminal or terminal emulation program as follows:
Baud rate | 38.4K |
Bits per character | 8 bits |
Parity | None |
Stop bits | 1 stop bit |
Flow control | None |
2.On the Terminal screen, enter root as the default username and root as the default password.
3.Verify the current IP address by entering ifconfig. As shown in Figure 2.3, the following default IP parameters display:
[IP ADDRESS] [NETMASK] [GATEWAY]
Figure 2.3: IP Parameter Summary
4.If you wish to change the IP address, enter setip on the Terminal screen. The following setup options display, as shown in Figure 2.4:
setip DHCP
setip IP ipaddress netmask [gateway]
NOTE: Using DHCP enables you to obtain IP address and network confi guration. Gateway is in brackets on the screen because it is optional.