16 MPX1000 Extender Installer/User Guide
Media Modules
Two types of media modules exist, as follows:
• Input media module for the transmitter
• Output media module for the receiver (shown below)
Media received from a source device at the input module of the transmitter is processed and passed
to bound receivers where it is properly converted and sent to display devices through the output
media module. Media modules must be installed in all MPX1000 extenders for proper operation.
NOTE: With your MPX1000 unit you have received two snap-on ferrites. If you are using the analog audio (RCA
Jacks) these ferrites should be applied to each end of the cables. Apply the ferrites approximately one inch from
the cable ends. One ferrite goes around both cables.

HDMI media module

For the HDMI media module, audio is limited to a single stream. HDMI digital audio, if present,
takes priority over analog audio.
RCA Jacks
(Unbalanced Audio)
HDMI Type A
Captive Screw
Figure 2.5: HDMI Media Module
Figure 2.5 illustrates an HDMI input media module. The HDMI output module, although reverse in
function, has a similar look and feel.
Supported resolutions are defined in MPX1000T HDMI Input Module Product Specifications on
page 62.

HD15 media module

The HD15 media module is intended for use with computer graphics and video.