48 MPX1000 Extender Installer/User Guide
• Primary status: The primary receiver is identified by the presence of Pri in the
name display
• Signal strength: reported by the receiver back to the transmitter
•Frame rate
Press the Up and Down buttons to manually scroll through status for all receivers. Press the Right
button to enter into a timed scrolling mode, which displays status of all receivers in a round robin
manner. If you press any button while in the timed scrolling mode, the display reverts back to the
sub-menu.
Press the Left button to return to the main menu.
Display Tx settings
The sub-menu for this selection allows you to display the following information:
• Transmitter identification: MAC address and friendly name
• Control LAN address (L1) Settings: IP address, subnet mask and gateway
• Media LAN Settings: Wireless channel number or Wired for wired configurations
• Video quality setting: presented as a target throughput value such as 20Mbps
• IR local loopback setting : On / Off
You may press the Up and Down buttons to manually scroll through these items. Press the Left
button to return to the main menu.
Configure control LAN
The sub-menu for this selection allows you to configure the following settings for transmitter’s
Control LAN (L1) port:
• IP address
• Subnet mask
• Gateway
To configure control LAN settings:
1. Press the Right button to select an octet for configuration. Octets are underlined when selected.
2. Press the Up and Down buttons to change the value of the selected octet as needed.
3. Press the Right button to select the next octet.
4. Repeat steps 2 and 3 until the IP address, the subnet mask and gateway address are all properly
configured.
5. Press the Right button until Save Change is displayed.
6. Press the Up and Down buttons to alternate between Yes and No.