Avocent SPC420 manual Click Next Click Finish

120DSView 3 Software Installer/User Guide

a.The Configure HP iLO Settings window will open.

b.In the Appliance Name field, type a 1-64 character appliance name. The name is not case sensitive.

c.In the Address field, type a 1-256 character IP address in dot notation form or a DNS name. The address is not case sensitive.

d.Click Next. Go to step 8.

7.For NEC IPF embedded appliances:

a.The Configure NEC IPF Settings window will open.

b.In the Address field, type a 1-256 character IP address in dot notation form or a DNS name. The address is not case sensitive.

c.In the Username field, type a 1-64 character username to be used to log in to the embedded appliance. Usernames are case sensitive.

d.In the Password field, type a 1-64 character password to be used to log in to the embedded appliance. Passwords are case sensitive.

e.Click Next.

f.The embedded device discovery will verify that the embedded appliance’s product ID matches the appliance type. If successful, the Select Options window will open.

g.The Appliance Name field contains the name stored in the embedded appliance. You may change this to a 1-256 character unique name. Names are not case sensitive.

h.Enable or disable the Allow target devices with the same name to be merged into a single target device checkbox.

i.Click Next.

8.Click Finish.

Adding managed appliances from a range or list of IP addresses

This procedure is valid for supported KVM switches and serial console appliances. It may also be valid for appliances supported by a plug-in; see the appropriate documentation.

To add a managed appliance from a range or list of IP addresses:

1.In a Units View window containing managed appliances (see Accessing Units View windows on page 106), click Add. The Add Appliance Wizard will open.

2.The Select Add Unit Procedure window will open.

3.To enter IP addresses as a delimited list, click Add multiple appliances, then click Next. Enter IPv4 and/or IPv6 addresses, separated by either a comma (,) or a semi-colon (;).

-or-

To enter an IP address range, click Discover appliances on the network from an IPv4 address range or an IPv6 subnet, then click Next. Select Use IPv4 address range and type the IP address from which to begin and end the search in the corresponding fields, or select Use IPv6 subnet and type the IPv6 network prefix in the corresponding field. Click Next.