Avocent SPC420 manual To add a spoke server, To register a hub server as a spoke server

	Chapter 5: DSView 3 Servers	73
Table 5.2: DSView 3 Software Spoke Server Status (Continued)
Status	Cause
Certificates Do Not	Certificates on the hub server and spoke servers do not match. See Managing hub and

Match	spoke server certificates on page 64 for information about updating the server
	certificates so that they will match.
Invalid Server or	A server responded, but it is not compatible with the DSView 3 software. This typically
	occurs when communication is attempted with a server that does not contain the
Versions Not
	software, or if either server contains an older version of the software. Ensure that both
Compatible
	servers are running the same DSView 3 software version.

To add a spoke server:

1.Install the DSView 3 software on the computer that will be used as a spoke server. See Installing the DSView 3 Software on page 10.

2.Configure the computer as a spoke server. See Configuring the DSView 3 Software on page 14.

To register a hub server as a spoke server:

Only DSView 3 software administrators may access this procedure.

NOTE: When registering a hub server as a spoke server on another DSView 3 software system, the information on the hub server being registered will be lost. Its database will be updated to match the new hub server to which it is being registered.

1.Click the System tab.

2.Click DSView Server in the top navigation bar. The side navigation bar will include the name of the server to which you are logged in.

3.Select Tools in the side navigation bar. The DSView Server Tools window will open.

4.Click the Register as Spoke Server icon or text. The Register Spoke Server Wizard will appear.

5.The Type in Hub DSView Server Address window will open.

a.Type the IP address of the hub server in standard dot notation (xxx.xxx.xxx.xxx) or the domain name of the hub server.

b.Type the port number for the hub server.

If the default hub server port value (443) is modified, you must specify it when registering a spoke server so that register requests will be sent to the correct port on the hub server. For example, if the IP address of the hub server is 10.0.0.1 and the port number is changed to 444, type https://10.0.0.1:444/dsview in the Address field of the Register Spoke Server Wizard.

c.Click Next.

6.The Operation in Progress window will open briefly, followed by the Accept Hub DSView Server Certificate window. Click Next.

7.The Type in Hub DSView Server Administrator Credentials window will open. Click Next.