Avocent SPC420 manual DSView 3 Software Installer/User Guide

136DSView 3 Software Installer/User Guide

3.Click Automatic Inheritance in the side navigation bar.

4.To allow new target devices to inherit group membership and properties from the appliance, select Allow new target devices to inherit the group memberships and properties from the corresponding appliance.

5.Click Save.

When automatic inheritance is enabled, the following occurs:

•When you use the Add Unit Wizard to add an appliance, you can specify the group for which you want the appliance to belong. Attached target devices will inherit these group memberships. Or, you can select Do not inherit group membership. See Adding a single managed appliance on page 116. Properties are not inherited at this time because the new appliance does not yet have any properties assigned.

•When new attached target devices are discovered using automatic topology synchronization, the Resync Wizard or the update topology task, the new target devices inherit group memberships and location, contacts, notes and custom field properties from the appliance. For more information about these operations, see Automatic topology synchronization on

page 131, Resynchronizing units on page 315 and Task: Update topology for selected units on page 331.