Chapter 5: DSView 3 Servers

67

 

 

Check the Enable Integrated Windows® Authentication checkbox to automatically log a user into the DSView 3 software using the Windows user’s computer credentials.

Web browser settings may need to be modified to allow users to automatically log in using Integrated Windows Authentication; see your web browser documentation.

5.To enable only DSView 3 software clients with IP addresses entered in the Address List to communicate with managed appliances, check the Restrict by address range checkbox. To disable address restrictions for logging into the DSView 3 software, uncheck this checkbox.

6.Enable or disable Allow login when user is a member of more than one authentication service as desired. The preset value is disabled. When enabled, if a user belongs to multiple authentication services, the DSView 3 server uses the first authentication service found to log the user in. When disabled, if a user belongs to multiple authentication services, the attempt to log in to the DSView 3 software fails.

When enabled, if a user has different access rights within each authentication service he belongs to, the user is granted access rights based on the first authentication service found by the DSView 3 server. In this case, a user may be granted different access rights at different login times.

NOTE: The Allow login when user is a member of more than one authentication service setting does not replicate to spoke servers. It is recommended that you uniformly enable or disable this setting on each DSView 3 hub and spoke server.

7.Click Save to store client session information in the DSView 3 software database on the host.

DSView 3 software modem sessions

For more information about modem sessions, see Active modem sessions on page 179.

NOTE: Modem sessions are available on supported ACS console servers.

To specify modem session properties:

1.Click the System tab.

2.Click DSView Modem Sessions in the side navigation bar. The DSView Server Modem Session Properties window will open.

3.Specify the following Session Timeout properties:

a.Inactive dial-up session timeout - in the drop-down menu, specify the number of seconds in the range of 60-3600 after which the session will be terminated. The default value is 120 seconds.

b.Dial-up connection attempt timeout - in the drop-down menu, specify the number of seconds in the range of 60-600 after which the attempt will be terminated. The default value is 120 seconds.

c.Dial-back connection attempt timeout - in the drop-down menu, specify the number of seconds in the range of 60-600 after which the modem will be removed from listening mode. The default value is 120 seconds.

Page 87
Image 87
Avocent SPC420 manual DSView 3 software modem sessions, To specify modem session properties