Avocent SPC420 manual Logging, To edit an existing macro group

Chapter 20: Using the Telnet Viewer 299

5.Click OK. The changes are saved and the Configure Macro Groups dialog box returns to its abbreviated view.

To edit an existing macro group:

NOTE: You must have DSView 3 software administrator privileges to edit global macro groups.

1.Select Macros - Configure - Groups from the menu. The Configure Macro Groups dialog box appears.

2.In the Macro Groups table, select the macro group you wish to edit.

3.Click the Edit button. The Configure Macro Groups dialog box expands to display an Edit Group area containing the information defined for the macro.

4.Edit the macro group properties as needed.

5.Click OK. The changes are saved and the Configure Macro Groups dialog box returns to its abbreviated view.

6.Repeat steps 2-5 to edit additional macro groups.

7.Click OK to close the Configure Macro Groups dialog box.

To delete a macro group:

NOTE: You must have DSView 3 software administrator privileges to delete global macro groups.

1.Select Macros - Configure - Groups from the menu. The Configure Macro Groups dialog box appears.

2.Select the macro group in the Macro Groups table that you wish to delete.

3.Click the Delete button. A dialog box appears, prompting you to confirm the deletion.

4.Confirm or cancel the deletion.

Logging

The Telnet Viewer has a logging function that saves the contents of a Telnet Viewer session to a file. You may enable automatic logging or dynamically start logging at any time. Additionally, you may pause, resume and stop logging, regardless of whether it was started automatically or dynamically.

While logging is occurring or when it is paused, a Logging Status label appears in the status panel at the bottom of the DSView 3 management software Telnet Viewer window.

NOTE: When you enable or disable automatic logging, the logging will begin or end at the start of the next DSView 3 software Telnet Viewer session to that device. If you change the default log file directory used for automatic logging, the change does not take effect until the next session to that device.