Axis Communications 223M Setting the root password, Accessing the camera from the Internet

AXIS 223M - Accessing the Camera 9

Setting the root password

1.When accessing the camera for the first time, the Configure Root Password dialog will be displayed on the screen.

2.Enter a password and then re-enter it, to confirm the spelling. Click OK.

3.The Enter Network Password dialog will appear. Enter the User name: root

Note: The default administrator user name root is permanent and cannot be deleted or altered.

4.Enter the password as set in step 2 above, and click OK. If the password is lost, the camera must be reset to the factory default settings. See Resetting to the factory default settings, on page 50.

5.If required, click Yes to install the AXIS Media Control (AMC). You will need administrator rights on the computer to do this.

Accessing the camera from the Internet

Once installed, the camera is accessible on your local network (LAN). To access the camera from the Internet you must configure your router/firewall to allow incoming data traffic. For security reasons this is usually done on a specific port. Please refer to the documentation for your router/firewall for further instructions.

For more information, please visit the AXIS Internet Dynamic DNS Service at www.axiscam.net or, for Technical notes on this and other topics, visit the Axis Support Web at www.axis.com/techsup

Setting the focus

To focus the AXIS 223M, follow the instructions below.

1.From the Basic Configuration page in the setup tools, open the Focus Adjustment page.

2.Set the DC-Iris to Disabled and click Save.

3.Unscrew the zoom puller on the lens by turning it anti-clockwise. Adjust the zoom setting as required. Re-tighten the zoom puller.

4.Unscrew the focus puller on the lens. Adjust the focus as required. Re-tighten the focus puller.

Zoom puller (Tele/wide)

Focus puller

5. From the Focus adjustment page, set the DC-Iris to Enabled and click Save.