Axis Communications P5522 Storage

AXIS P5522 PTZ Dome Network Camera

System Options

The following traps are available:

•Coldstart

•Warmstart

•Linkup

• Authentication failed

SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.

To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 37. To enable SNMP v3, check the box and provide the initial user

password.

Note

The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see

Reset to factory default settings, on page 46.

UPnPTM

The Axis product includes support for UPnPTM.UPnP

TM is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

UPnPTM can be disabled under System Options > Network > UPnPTM.

The RTP port range and multicast settings are conﬁgured under System Options > Network > RTP.

The RTP port range deﬁnes the range of ports from which the video/audio ports are automatically selected. For multicast streams,

only certain IP addresses and port numbers should be used.

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

Bonjour can be disabled under System Options >Network>Bonjour.

Storage

The SD/SDHC memory card (not included) is managed on the System Options > Storage > SD Card page.

The settings under Storage Device are used to identify and monitor the status of the SD card, and to unmount the SD card

before removal. Mounting is done automatically when a car d is inserted. SD cards are normally preformatted when purchased,

but if needed, click Format to format the card.

Note

To prevent corruption of recordings, the SD card should always be unmounted before removal.

If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair.

The settings under Storage Device Settings are used to conﬁgure removal of recorded video. Automatic disk cleanup can be enabled

and set according to a schedule. The disk can be locked to prevent removal of recordings.

For more information, see the online help .