B&K 1788, 1786B, 1785B, 1787B instruction

Instruction Manual

Model 1785B, 1786B, 1787B & 1788 Programmable DC Power Supplies

Image 1

B&K 1788, 1786B, 1785B, 1787B instruction manual

Contents

Page Content Quick Reference About your safetyGeneral information Protection from electric shock Introduction Certification and WarrantyCertification Front Panel at a Glance Menu description Function keys descriptionDisplay annunciators Cal Rear Panel at a Glance Quick Start Connect the power cord and turn on the power supplyPreliminary Checkout Check the list of supplied items Voltage Output Checkout Output CheckoutCurrent Output Checkout To Adjust the Carrying Handle If the Power Supply Does Not Turn OnVerify that there is AC power to the power supply Verify the power-line voltage setting Bench-top viewing positions Carrying position To Rack Mount the Instrument Specifications Specifications Maximum input power Supplemental Characteristics Environmental Conditions Unit mm Front-panel Operation Overview Front-panel OperationConstant Voltage Operation Saving and Recalling Operation Constant Current OperationMenu Operation Set Maximum voltageMAX Volt Setting the Baud RateBAUDRATE Setting the Key SoundKEY SoundInitiating the Output stateINIT OUT Initiating the Output Voltage Init Volt Setting password for function keysKEY Lock Setting Address Address Communication setting Remote Operation ModeIT-E131 Communication cable Frame format Setting the remote control mode 20HCommunication protocol Description Setting the maximum output voltage 22H Setting the output state ON/OFF 21HSetting the output voltage 23H Setting the communication address 25H Setting the output current 24H Reading the calibration state 28H Entering the calibration mode 27H Calibrate the current value 2BH Calibrating the voltage value 29H Save the calibration data to Eeprom 2DH Setting calibration information 2EHReading calibration information 2FH Enable the local key 37H Restore the factory default calibration data 32HReturn information of command operation in power supply 12H Calibration Voltage calibration ConfigurationCurrent calibration Finish calibrating Installation Reset to the default calibration settingsPV1785B1788 Software Functions of PV1785B1788 Status bar 1Configure the system Quickly setting Setting Voltage and current 4. GO/NG Test Function Program setting Chart Description Present Voltage/Current ChartSave and Open Page Limited One-Year Warranty Service Information USA