Bacharach INSIGHT manual Insight

Fyrite® INSIGHT

Inspect the flue-gas hose for cracks. If a hose is defective, replace the en- tire probe assembly.

Fyrite® INSIGHT

Fyrite® INSIGHT Connectors

Before using the analyzer, check that the Water Trap / Filter is dry and not dirty. If necessary, dry out the trap and replace the filter element per Section 6.2.

Perform the following steps to connect the probe assembly to the Fyrite

INSIGHT:

1.Push the probe’s sample-gas hose onto the GAS inlet fitting.

2.Push the probe’s draft hose onto the “+” pressure fitting.

3.Push the probe’s thermocouple into the T-STACK jack

Important: DO NOT force the thermocouple connector into its jack. The connection tabs are different sizes, allowing the connector to fit in only one way.

4.Push the optional ambient/primary-air thermocouple into the T-AIR jack.

AC Power Adapter Jack (Power)

Differential
Pressure Hose	Draft
(Optional)
	Hose

Sample Gas

Thermocouple

Connector (T-Stack)

Probe

Tube

Probe

Stop

USB Cable

Primary Ambient Air Thermocouple (T-Air) (Optional)

Sample Gas

Hose

Water Trap/

Filter Assembly

Probe

Handle

Fig. 3.1

8 Instruction 24-9460 Instruction 24-9460 9