Barco Fusion 4MP manual How to use the controls, Standby touch key, Power LED, Display information

Display information

To display the OSD (on-screen display). In the OSD, this button acts as Enter button to make selections.

4.Standby touch key

To put the display in standby mode.

5.Power LED

Indicates the display’s power status.

Green: Display is on (when enabled in the OSD).

Orange: Display is in Standby power-saving mode.

Off: Display is disconnected from the power or the LED’s on state is disabled in the OSD.

Note: When the LED is disabled in the OSD, it will still be activated (green) when the display is on but does not receive any video signal.

How to use the controls

1.When the OSD is not on the screen, touch any of the soft touch keys.

The front illumination is switched on for about 10 seconds.

2.While the illumination is on, touch the Enter touch key to display the main menu. It contains several submenus.

3.To open a submenu, use the Up or Down touch keys to select the submenu. Next, press the Enter touch key to open the submenu.

4.To exit from a submenu, use Up or Down to select EXIT. Next, press Enter .

If you exit from the Main Menu, you exit the OSD.

5.To change an adjustment value or setting, use Up or Down to select the adjustment or setting. Next, press Enter to go

18