Barco R9002790 manual Terminology, Rcu

Getting Started

Terminology

1Barco key : = selection key, to get direct access to the lens adjustment menus.

2ADJ. : ADJUST key, to enter or exit the adjustment mode.

3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with a pencil, followed by pressing one digit button between 0 and 9.

4STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching off the power switch.

5PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate restarting.

6Help : on line help information (not yet available)

7Digit buttons : direct input selection.

8Picture controls : use these buttons to obtain the desired picture analog level.

9PHASE : used to remove the instability of the image.

10TEXT : when adjusting one of the image, e.g. controls during a meeting, the displayed bar scale can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again.

When TEXT is 'off', no adjustment menu's will be displayed on the screen when entering the adjustment mode.

11FREEZ : press to freeze the projected image.

12ENTER : to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.

13EXIT : to leave the adjustment mode or to scroll upwards when in the adjustment mode.

14Cursor Keys (on RCU) or '+' and '-' keys (cursor keys) on the local keypad : to make menu selections when in the adjustment mode or to zoom/focus when the direct access is active.

Comparision between the cursor keys and the use of the '+' and '-' keys on the local keypad :

RCU		=	local keypad
cursor key up	=	'+' key up
cursor key down	=	'-' key down
cursor key right	=	'+' key right
cursor key left	=	'-' key left

Use the '+' and '-' keys (cursor keys) : to increase or decrease the analog level of the image controls when they are first selected.

15RC operating indication : lights up when a button on the remote control is pressed. (This is a visual indicator to check the operation of the remote control)

5-2 R5976336 BARCOSLM R6 Executive 06092001