DS72 HOST MODULE OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
DS72 CONFIGURATION If you are using the Menu Selection Method, select C, “Configure,” followed by <cr> from the DS72 Main Menu. The following selection menu appears:
| Configuration |
|
| Module 1 | 1 |
| Module 2 | 2 |
| Module 3 | 3 |
| Select Port | S |
| Exit | X,CR |
| Enter request: |
|
| If you are using the ASCII Character String Method, exit the main menu, | |
| then select the module to configure. To select Module #1, type $BT1<cr>. | |
| The DS72 responds “Requested Connection Made.” Send the ASCII | |
| configuration command $CONFIG. The configuration menu appears. | |
| Enter the number of the module to configure, followed by <cr>. To | |
| configure the host module 1, select #1. The following configuration menu | |
| appears for the DS72: |
|
| Copyright(C) Bay Technical Associates 1998 | |
| ||
| Revision F.1.00 |
|
| Module 1 |
|
| Status | 1 |
| Serial Port Configuration | 2 |
| Port Device Name | 3 |
| Port Select Code | 4 |
| Attention Character | 5 |
| Disconnect Timeguard | 6 |
| Connect Port ID Echo | 7 |
| Login Setup | 8 |
| Network Port Configuration | 9 |
| Unit ID | 10 |
| Configure Another Module | 11 |
| Exit | X,CR |
| Enter Request: |
|
STATUS | View the status of most user | programmable features by selecting #1, |
| “Status,” from the configuration menu, followed by <cr>. The following | |
| menu appears: |
|
| Installed Modules : |
|
| Port Select Code is | $BT |
| Attention Character is | ; |
| Disconnect Time Guard is | Enabled |
| Port ID Echo is | Device Name |
| Unit ID is | BAYTECH DS72 |
| Network Setup : |
|
| Ethernet Address | 00.C0.48.06.1A.81 |
| IP Address | 200.4.2.65 |
| Subnet Mask | 255.255.255.0 |
| Gateway | 200.4.2.1 |
| Inactivity Timeout (mins) | 1 |
| Break Length (msecs) | 350 |
10
