Bay Technical Associates DS72 Detailed Operation and Configuration, Accessing Main, Menu

DS72 HOST MODULE OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

DETAILED OPERATION AND CONFIGURATION

The following section, “Detailed Operation and Configuration,” provides a detailed approach to accessing, operating, and configuring the DS72 network interface module.

NOTE: It is important that you type all commands correctly. Any combination of wrong entries results in an error message.

ACCESSING MAIN	Apply power to the module. The following header and main menu appear:
MENU
	Data Switch Series - F.1.00
	Bay Technical Associates
	Unit ID: BAYTECH DS72
	Port Select Code: $BT
	Attention Character: ;
	Device A	(2,1)	1
	Device B	(2,2)	2
	Device C	(2,3)	3
	Device D	(2,4)	4
	DS-RPC	(3,1)	5
	Configure		C
	Status		S
	I/O Modules Reset		RM
	Unit Reset		RU
	Exit		X
	Logout		T

Enter Request :

NOTE: Depending on the DS-Series model, the menus may vary according to the number of DS74 modules installed in the unit.

If this is not an initial set-up and Password has already been enabled, you are prompted to login. After logging in successfully, the main menu will appear.

NOTE: Password feature is case sensitive.

SELECTING A DEVICE There are two methods of selecting a device, menu driven selection and

	ASCII character string method.
Menu Driven	From the main menu, select the number that corresponds to the device you
Selection	wish to access, followed by <cr>. To return to the main menu, send the
	attention character five times (;;;;;).
ASCII Character	Another method of selecting devices and operating the DS-Series and DS
String	RPC is the ASCII character string method. To select a device located on
	a peripheral Port, type $BTm,p where m is the module and p is the port.
	To configure a module, type $BT and the module number followed by

8