Step-by-Step Installation Guide
This section provides complete instructions for the hardware setup of a
single Switch.
Important Note
Before attempting to connect anything to the Switch or to any computer, make
sure that everything is powered off. Plugging and unplugging cables while
computers are powered on can cause irreversible damage to your computers,
data, and/or to the Switch. Belkin Corporation will not be responsible for damage
caused in this way.
Connecting the Console
1. Connect your PS/2 type keyboard
and mouse to the KEYBOARD and
MOUSE ports located on the side
of your Switch.
98
INSTALLATION
INSTALLATION
Pre-Configuration
Where to Place the Switch
The Switch is designed for positioning on the desktop. The exact placement will
be based on the location of your CPUs and length of your cables.
Cable Distance Requirements
For PS/2 computers: VGA signals are best retained when transmitted up to 25
feet (7.6m). Beyond 25 feet, probability of video degradation increases with
an increase in distance. For this reason, your PS/2 computer should be placed
within 25 feet of the KVM Switch.
Note: If your computer needs to be more than 25 feet from the KVM Switch, you
can use the Belkin CAT5 Extender (part number F1D084) to extend your PS/2
keyboard, PS/2 mouse, and monitor up to 500 feet (152.4m) away using a
standard CAT5 UTP cable.
Cautions and Warnings
Avoid placing cables near fluorescent lights, air conditioning equipment, or
machines that create electrical noise (e.g., vacuum cleaners).
INSTALLATION
P74711ea_F1DJ10x_man.indd 8-9 12/11/04 11:35:37 am