Belkin PM01218ea F5D7634-4 user manual Connecting and Configuring your Router

Connecting and Configuring your Router

Table of Contents	sections	1	2	3	4	5
1.1 Brand-New Setup
Follow these steps if you are not
replacing an existing modem.				2		3
If you are replacing an existing

modem, skip to the next section,
“Replacing an Existing Modem or
Modem Router”.	2

6 7 8 9 10

1

1.Retrieve the yellow RJ45 cable that was included with your Router. First, connect one end to any yellow port labeled “to Wired Computers” on the back of your Router. Then, connect the other end to the networking port on the back of your computer.

2.Retrieve the included gray RJ11 phone cord. Connect one end to the gray port labeled “to ADSL” on the back of your Router. Then, connect the other end to your ADSL connection (either a wall jack or an ADSL splitter).

Note: Some ADSL connections require a micro filter. Your ADSL provider can tell you if you need one. Belkin includes a micro filter in regions known to use them. You may or may not have received one in your box.

3.Plug your Router’s power supply into the black port labeled “Power” on the back of your Router.

4.Wait 20 seconds for the Router to start up. Look at the display on the front of the Router. Make sure the “Power” and “LAN (1-4)” LEDs are lit up in green.

G Wireless Modem Router 11