Belkin Pre-N manual LAN Settings, IP Address, Subnet Mask, DHCP Server, IP Pool

Manually Configuring your Router

LAN Settings

(1)

(2)

(3)

(4)

(5)

1.IP Address

The “IP address” is the internal IP address of the Router. The default IP address is “192.168.2.1”. To access the setup interface, type this IP address into the address bar of your browser. This address can be changed if needed. To change the IP address, type in the new IP address and click “Apply Changes”. The IP address you choose should be a non-routable IP. Examples of a non-routable IP are:

192.168.x.x (where x is anything between 0 and 255) 10.x.x.x (where x is anything between 0 and 255)

2.Subnet Mask

There is no need to change the subnet mask as the router will automatically adjust the length based on the IP address type.

3.DHCP Server

The DHCP server function makes setting up a network very easy by assigning IP addresses to each computer on the network automatically. The default setting is “On”. The DHCP server can be turned OFF if necessary, however, in order to do so you must manually set a static IP address for each computer on your network. To turn off the DHCP server, select “Off” and click “Apply Changes”.

4.IP Pool

The IP Pool is the range of IP addresses set aside for dynamic assignment to the computers on your network. The default is

26